![]() ![]() If set, this will override the default computer name. Specify the name that a computer will use during a remote desktop session. This will inform the user that the connection was dropped and will allow them to take actions on their own. Specifies the number of seconds after which the connection banner will be displayed in Parallels Client. Show connection banner if reconnection is not established within.The Connection retries property specifies the number of retries. if this option is selected, Parallels Client will try to reconnect if the connection is dropped. In this pane, specify what to do if the connection is dropped: If the primary connection cannot be established, Parallels Client will use secondary connections in the order listed. If you have multiple secondary connections, you can move them up or down in the list. Select the connection mode and modify the default port number if necessary.In the Secondary connections pane, click Tasks > Add and specify a server name or IP address.If you have more than one RAS Secure Client Gateway, you can define a secondary connection, which will be used as a backup connection in case the primary gateway connection fails. Specify the domain name (if credentials are used for authentication).This means forcing a client to save the password for this connection. Select or clear Save password as needed (if credentials are used for authentication).Note: The allowed authentication type(s) must be specified in the RAS Console in Connection > Authentication. For more info, see SAML SSO Authentication. If selected, the SAML SSO authentication is allowed. When connecting to the remote server, a user will need to insert a smart card into the card reader and then enter a PIN when prompted. ![]() Select this option to authenticate using a smart card. The credentials that the user used to log on will be used to connect to the remote server. This option will be included in the list only if the Single Sign-On module is installed during Parallels Client installation. The user will have to enter credentials to log on. In the Authentication type drop-down list, select the desired method of authentication:.If the option is disabled, auto login will be disabled in HTML5 Client and the user will not be able to change it. Auto login: Enable or disable auto login in RAS HTML5 Client.Specify a friendly name for the connection.The primary connection always defaults to the primary RAS Secure Client Gateway, but you can modify the following connection properties: To configure connection properties, select the Connection node and then go through each child node configuring their respective properties. ![]()
0 Comments
Leave a Reply. |